The vehicle was taken to the dealer yet he was unable to locate an oil leak. That is the … only way to do it if you don't have a code reader that can communicate with the controller and its memory. Drive it a couple miles so the oil is nice and hot. Based on the reading I've done, this is a too common problem. The contact stated that when the vehicle was turned on, the check engine light and the p517 code light illuminated. Turn the ignition to the on position, but don't start the vehicle 2.
Run for 45 seconds and shut down. The van runs decent but it has a lost some power as it take awhile to speed on on highways. Said that according to their records the win module had been replaced on my van and that my vehicle had been repaired on 2-7-2012. This is a very well done tutorial for those who have never done an oil change on their own car. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Chrysler cars. Kindly look in to issuing a recall for this problem.
The vehicle was not repaired. This is a wide spread problem that Chrysler needs to man up and accept responsibility and repair their customers vehicles properly. Been to independent mechanic and have try several correction but no luck. The dealer diagnosed that the cam shaft was fractured. Chrysler has denied the lawsuit.
The contact stated that the vehicle continued to burn oil and the climate control failed. I shouldn't have to check the oil every 500 miles. The contact stated that while driving 60 mph, the vehicle stalled and would not restart. This is clearly a design flaw to this particular engine. Oil Change Light Reset Chrysler Town and Country 2008 2009 2010 The Oil Change Light Reset Chrysler Town and Country 2008 2009 2010 will need to be performed after every oil change. The contact stated the check engine warning light illuminated. Also the key is getting stuck in the ignition after being shut off.
Checking the oil in a Town and Country is fairly easy and should be done once a month. The vehicle was towed to the contact¿s residence. It was easily removed after I wasted about 4 quarts of oil. Tried again to start van was successful but check engine light came on. The contact stated that the engine oil light illuminated and he discovered there was very little oil in the engine.
This has happened before and our mechanic performed the repairs. The approximate failure mileage was 74,123. Is it a brake pedal or the excelorator pedal that is to be pushed many many many times? Also, why is there a photo of a foot on a brake pedal? I had no electrical controls. Generally, I just make it as tight by hand as possible. This is definitely a safety issue!!.
Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Chrysler cars. You now know the capacity. There are no leaks or wet spots under the hood or on the ground. About a month later we were driving home from a soccer game and the car came out of gear while driving about 70 mph. I tried waiting a couple of gas tanks to see if it would turn off automatically. I had the car towed in to the dealer and they told me that the car was not communicating with the computer and they had no idea what the problem was. The dealer also stated that the oil was burning normally.
To reset the system, close the door and hood. Make sure your engine is cold when you check the oil in your Town and Country. If the bolt in your vehicle is not grey, replace it with part number 06101793. Due to this problem I will never purchase a Chrysler vehicle again. Note: Make sure that there is a gasket on the filter! The diagnosis was a airbag sensor. The failure mileage was 100,000.