Wait until it is safe to operate Mobile Communications Equipment. Front air bags and pretensioners are designed to activate only in frontal and near-frontal collisions, not rollovers, side-impacts, or rear-impacts unless the collision causes sufficient longitudinal deceleration. This value is not the same as the average fuel economy display. Refer to Safety Restraints for Children or Safety Seats for Children later in this chapter. Unsupervised children could lock themselves in the trunk and risk injury. If you do not install and use the safety seat properly, the child may be injured in a sudden stop or collision. Over time, the adaptive learning process will fully update transmission operation.
If the power steering system breaks down or if the engine is turned off , you can steer the vehicle manually, but it takes more effort. Only SecuriLock keys can be used. Driving through deep water where the transmission vent tube is submerged may allow water into the transmission and cause internal transmission damage. Some brake dust is inevitable as brakes wear and does not contribute to brake noise. Press and hold the bottom part of the rocker switch to open the window.
Note: If the bulb is accidentally touched, it should be cleaned with rubbing alcohol before being used. All of the vehicle doors will lock and then unlock to confirm erasure. Children 12 years old and under should be properly restrained in the rear seat whenever possible. Within seven seconds of the safety belt warning light turning off, buckle then unbuckle the safety belt. When towing, trailer tongue load or king pin weight is also part of cargo weight. Erasing personal code To erase all of the personal entry codes programmed to a vehicle: 1.
This system is designed to prevent the engine from being started unless a coded key programmed to your vehicle is used. However, avoid taking any unnecessary risks. It does not include passengers, cargo, or optional equipment. . The rolling code equipped device should now recognize the HomeLink signal and activate when the HomeLink button is pressed.
The BeltMinder feature will not activate. This will take up to three circles to complete calibration. Each number must be entered within five seconds of each other. The interior lamps will illuminate. If you smell exhaust fumes inside your vehicle, have your dealer inspect your vehicle immediately.
Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. The heated seat module resets at every ignition run cycle. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. Install the bulb socket into the lamp assembly by rotating it clockwise. Inspect the safety belts to make sure there are no nicks, tears or cuts. Automatic locking mode In this mode, the shoulder belt is pre-locked. The anchors on both sides of the center of the rear seat are provided for child seats at the outboard seats, and are further apart than the pairs of lower anchors for child seat installation at other seats.
Batteries contain sulfuric acid which can burn skin, eyes and clothing, if contacted. Frontal airbags are not designed to inflate in rear and side crashes or rollovers. The automatic locking mode is not available on the driver safety belt. If the engine still fails to start, press the accelerator to the floor and try again; this will allow the engine to crank with the fuel shut off in case the engine is flooded with fuel. The rear doors can be opened from the outside when the doors are unlocked.
Confirmation of enabling BeltMinder is provided by flashing the safety belt warning light four times per second for three seconds, followed by three seconds with the safety belt warning light off, then followed by flashing the safety belt warning light four times per second for three seconds again. All that you ever need to drive, service and repair your Ford Crown Victoria 2008, Ford Crown Victoria 2009, Ford Crown Victoria 2010, Ford Crown Victoria 2011 or Ford Crown Victoria 2012. Ford has around 90 facilities worldwide and counted about 213. Always come to a complete stop before shifting into and out of R Reverse. We have no permissions to change or modify the file and all responsibilities belong to host.