Bulletin: 05-00-89-055E Component: 356000 equipment adaptive Summary: This warranty administration bulletin provides information to clarify proper transaction administration of gm dealer empowerment program and goodwill cases. Dealers will replace the crankshaft position sensor. A seat that does not stay secured increases the risk of occupant injury in a vehicle crash. Owners may unknowingly draw too much current through the vehicle's trailer harness resulting in the melting of fusible link for the auxiliary battery. Dealers will make sure the bolts are properly tightened.
In the affected vehicles, the chassis electronic module may be internally contaminated, resulting in an electrical short. That causes the engine to stall, disabling power steering, power brakes and air bags. If stuck in the 'start' position, the ignition may suddenly snap back into the 'accessory' position, causing a loss of engine, steering, and braking power, increasing the risk of a vehicle crash. Approximately 67,000 additional trucks that were exported and sold in Canada and Mexico also are being recalled. The manufacturer has not yet provided a notification schedule. The biggest recall announced Wednesday covers 475,000 newer cars and trucks worldwide 414,333 in the U.
This movement may result in the fatigue and separation of the cable. These repairs will be performed free of charge. Bulletin: 15-08-44-001B Component: 353000 equipment:electrical Summary: This informational bulletin provides information on a gm of canada onstar® cellular communication upgrade. The expanded recall affects 824,000 vehicles in the U. The recall began on May 30, 2014. Automotive News reported the recall Thursday, citing a notice sent to dealers. Dealers will remove the heated washer fluid module and reroute washer fluid hoses.
The auto company said customers will begin to receive recall letters later this month but can contact their dealer to make an appointment to have the heated washer system removed. The recall is expected to begin on April 28, 2014. The manufacturer has not yet provided a notification schedule. This information is supplied for personal use only and may not be used for any commercial purpose whatsoever without the express written consent of Chrome Data. The owners will also be provided an insert for their owners manual instructing them not to use floor mats, free of charge.
The manufacturer has not yet provided a notification schedule. If contact occurs, the air bag warning light will turn on. On some vehicles, a gasket leak where the constant velocity joint meets the rear propeller shaft may cause the rear propeller shaft to separate or become loose, making contact with the vehicle floor above and causing the rollover sensor to inflate roof-rail air bags. Bulletin: 04-00-89-015J Component: 356000 equipment adaptive Summary: This warranty administration bulletin communicates gm required operating procedures u. Bulletin: 02-07-30-052J Component: 103000 power train:automatic transmission Summary: This informational bulletin provides technicians with information regarding automatic transmission oil cooler flow test essential tool j-45096 transflow®. Remedy: General Motors will notify owners and dealers will replace the passenger air bag module, free of charge. The manufacturer has not yet provided a notification schedule.
If the fusible link melts it may come into contact with adjacent components, damage the electrical center cover, the nearby wiring harness conduit and other vehicle components, increasing the risk of a fire. General Motors will notify owners and dealers will replace the passenger air bag module, free of charge. The driver could then lose control of the vehicle. But no crashes have been reported. Until then, owners of recalled cars are urged to remove additional weight from key chains and drive with only the ignition key. The recall is expected to begin in ealry August 2014. Customers are advised to take the floor mats to their dealer for a full refund.
Dealers will install a new rear axle cross pin free ofcharge. Additionally, a loose pedal may also interfere with the accelerator pedal. Due to an improper heat-treatment, the rear axle shaft may fracture while the vehicle is being driven. An updated page for the owner manual will be provided and inserted in the owner manual to document that the feature has been permanently disabled and removed from the vehicle. The rear axle cross pins were not properly heat treated and could fracture and become displaced within the rear axle. Bulletin: 06-03-09-004H Component: 022140 suspension:rear:springs:leaf spring assembly Summary: This technical bulletin provides a procedure to lube the rear leaf springs on vehicles with the condition of a squeak noise originating from the rear of the vehicle. Should the pin shift out of position, it could create an interference condition and cause the rear axle to lock.
The radios in the affected vehicles may become inoperative, and as a result, there would be no audible chime to notify the driver if the door is opened with the key in the ignition or no audible seat belt warning indicating the seat belts were not buckled. Bulletin: 13-08-116-001B Component: 353000 equipment:electrical Summary: The intent of this technical bulletin is to identify aftermarket aldl or dlc interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them. Hazard: A seat that does not stay secured increases the risk of occupant injury in a vehicle crash. Due to an incomplete weld on the seat hook bracket assembly, the front seats in the affected vehicles may not stay secured in place during a high load condition such as a crash. While being previously remedied for recall 16V-651, the affected vehicles may not have received the complete software update necessary to remedy the recall condition. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment.
In the affected vehicles, the chassis electronic module may be internally contaminated, resulting in an electrical short. As a result the air bag may not fully inflate, increasing the risk of injury. Going forward, attention will be focused on whether sales and values are impacted on these models. The recall began on August 4, 2017. If the brake pedal becomes loose or inoperative, the driver may be unable to stop the vehicle by using the brake pedal. The recall is expected to begin on April 28, 2014.